Filter
Top Products
2. To install the solid-state drive with the storage converter into the 3.5-inch hard disk drive bracket, flex
the bracket and align pin 1 , pin 2 , pin 3 , and pin 4 on the bracket with the corresponding holes in
the storage converter.
Figure61. Installing the solid-state drive with the storage converter into the hard disk drive bracket
3. Install the solid-state drive into the desired hard disk drive bay. See “Replacing the primary hard disk
drive” on page 70
or “Replacing the secondary hard disk drive” on page 72.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 99.
Replacing the front fan assembly
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
on page v.
This section provides instructions on how to replace the front fan assembly.
Note: The front fan assembly is only available in some models.
To replace the front fan assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 40.
3. Disconnect the front fan assembly cable from the power fan connector on the system board. See
“Locating parts on the system board” on page 13
.
Chapter 5. Installing or replacing hardware 75