Filter
Top Products
7. Remove the card reader retainer from the old front USB assembly and install it on the side of the new
front USB assembly.
Figure36. Installing the card reader retainer
8. Slide the new front USB assembly with retainer into the card reader drive bay until it snaps into position.
Figure37. Installing the front USB assembly
9. Connect the cable of the new front USB assembly to the front USB connector 2 on the system board.
See “Locating parts on the system board” on page 13.
10. Reinstall the front bezel. See “Removing and reinstalling the front bezel” on page 41.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 99.
Replacing the battery
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
on page v.
Chapter 5. Installing or replacing hardware 57