Filter
Top Products
Plugs and outlets
DANGER
If a receptacle (power outlet) that you intend to use with your computer equipment appears to be
damaged or corroded, do not use the outlet until it is replaced by a qualied electrician.
Do not bend or modify the plug. If the plug is damaged, contact the manufacturer to obtain
a replacement.
Do not share an electrical outlet with other home or commercial appliances that draw large amounts
of electricity; otherwise, unstable voltage might damage your computer, data, or attached devices.
Some products are equipped with a three-pronged plug. This plug ts only into a grounded
electrical outlet. This is a safety feature. Do not defeat this safety feature by trying to insert it into
a non-grounded outlet. If you cannot insert the plug into the outlet, contact an electrician for an
approved outlet adapter or to replace the outlet with one that enables this safety feature. Never
overload an electrical outlet. The overall system load should not exceed 80 percent of the branch
circuit rating. Consult an electrician for more information if you have questions about power loads
and branch circuit ratings.
Ensure that the power outlet you are using is properly wired, easily accessible, and located close to
the equipment. Do not fully extend power cords in a way that will stress the cords.
Ensure that the power outlet provides the correct voltage and current for the product you are
installing.
Carefully connect and disconnect the equipment from the electrical outlet.
Power supply statement
DANGER
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a problem with
one of these parts, contact a service technician.
External devices
CAUTION:
Do not connect or disconnect any external device cables other than USB while the computer power is
on; otherwise, you might damage your computer. To avoid possible damage to attached devices, wait
at least ve seconds after the computer is shut down to disconnect external devices.
viii User Guide