Filter
Top Products
2
1
When installing: Install the battery pack in the slot, and then make sure that the battery latch is in the
locked position.
1020 Serial Ultrabay Enhanced device or blank bezel
For access, remove this FRU:
• “1010 Battery pack” on page 68
Removal steps of Serial Ultrabay Enhanced device or blank bezel
Hold the bay lock latch in the unlocked position 1 and slide the bay eject latch 2 . Then, pull out the Serial
Ultrabay Enhanced device or the blank bezel in the direction shown by the arrow 3 .
3
2
1
Note: For RAID models, to remove the second hard disk drive, you need to remove the screw that secures
the second hard disk drive adapter rst.
Chapter 10. Removing or replacing a FRU 69