Filter
Top Products
Notes:
• The hot-swap hard-disk-drive backplane is sensitive to ESD. Ensure that you read and understand
“Handling static-sensitive devices” on page 68
rst and carefully perform the operation.
• Depending on the model, your server might look slightly different from the illustrations in this topic.
• The illustrations in the following procedure show the backplane for 3.5-inch hard disk drives. For the
backplane for 2.5-inch hard disk drives, the replacement procedure is similar.
• In the following illustrations, system fans are removed in order to make the hot-swap hard-disk-drive
backplane clearly visible.
To replace the hot-swap hard-disk-drive backplane, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a at,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server.
3. Remove the server cover. See “Removing the server cover” on page 69.
4. Locate the hot-swap hard-disk-drive backplane. See “Hot-swap hard-disk-drive backplane” on page 33.
5. Remove all the installed hot-swap hard disk drives and dummy trays (if any) from the hard-disk-drive
bays. See “Installing or replacing a hot-swap hard disk drive” on page 115.
6. Record the cable connections on the backplane and then disconnect all the cables from the backplane.
7. Press the two retaining latches in the direction as shown to release the backplane.
Figure103. Releasing the hot-swap hard-disk-drive backplane
Chapter 6. Installing, removing, or replacing hardware 133