Filter
Top Products
2-2 Service Manual
4069-XXX
Service Error Codes
Service Error Codes are generally non-recoverable except in an
intermittent condition when you can POR the printer to temporarily
recover from the error condition.
Error Code Action
900 RIP Software Contact the next support level or call Lexmark.
901 Engine Flash Indicates that the flash which the engine board code is
programmed into is bad. Replace the engine board.
902 General
Engine Software
These errors indicate an unrecoverable engine software
error. Replace the engine board.
Check for correct location of the jumpers on the
interconnect board for the model/type printer you are
servicing. Incorrect jumper settings can cause a 902
service error. If jumpers are set correctly, replace the
engine board.
903 Paperport
Link Driver Error
904 Interface
Violation by the
controller
software
905 Interface
Violation by
Paperport Device
906 Controller-
Engine Link
Driver Error
910 DC Pick
Motor DC Pick
Motor Stall
Error Codes 910,911,912,913 and 914 are indications
that a Tray 1 paper feed problem has been detected. Go
to the “Input Tray(s) Option Service Check” on
page 2-51.
911 DC Pick
Motor Excessive
PWM
912 DC pick
motor below
speed
913 DC pick
motor over speed