Filter
Top Products
2-56 Service Manual
4069-XXX
The base printer indicates a dead machine condition when the
high capacity input tray is installed.
FRU Action
1 AC Line Cord
AC Jumper (HCIT to
Printer)
AC input and Output
Receptacles
AC Wiring Harness
If the base printer works normally
using the AC line cord from the AC
wall outlet and does not work when
using the AC jumper from the HCIT,
check the AC jumper cord. If
defective, replace the cord. If not
defective, check the AC input and
output receptacles and wiring
harness in the HCIT. Repair or
replace the receptacles or AC wiring
harness as required.
NOTE: Make sure the ground wire is
installed correctly from the AC wiring
harness to the frame of the HCIT
and the nut and lockwasher are
tightened down.