Filter
Top Products
Diagnostic Information 2-63
4069-XXX
The elevator tray does not move up or down. The printer
recognizes that the option is installed.
FRU Action
1 DC Drive Motor High
Capacity Feeder Option
System Board
Be sure the motor cable is correctly
installed at J1 on the board. Check
the cables, damaged or loose wires.
Disconnect the motor. Check for a
short between each pin and the
motor housing. If a problem is found,
replace the motor assembly. If no
problem is found, measure the
resistance between the following
pins on the motor cable connector:
Pins 1 (brown) and pin 2 (Yellow)
The resistance measures between
approximately 7.5 and 10.5 ohms. If
incorrect, replace the motor
assembly. If correct, replace the high
capacity feeder option system board.