Filter
Top Products
23
9.1. Disassembly lnstructions
9.2.1. Preparation
Attention:
Before disassembly, be sure to perform the
following steps.
1. End the Windows.
2. Turn off the power and then remove the AC adap-
tor.
3. Slide the hooks (A) and then remove the battery
pack.
4. Remove the screw (A) and then remove the DIMM
cover.
(Remove if the DIMM memory is equipped with)
Screw (A) : XSB2+4FNL (N16)
9.2.2. Removing the Keyboard
Preparation : perform the section 9.2.1.first.
1. Remove the 4 screws (B).
Screw (B) : DXQT2+E12FNL (N11)
2. Remove the 2 keyboard hook plates,and then
remove the hook of back side of keyboard with
screw driver.
LCD Knob
Hook(B)
LCD Unit
Hook(B)
6. Remove the heat spreader from buttom of the
keyboard.
7. Remove the keyboard FFC from the connector
(CN15) and then remove the keyboard.
Heat Spreader
CN15
KeyBoard
3. The LCD unit is opened up to about 90 °by operat-
ing the LCD knob.
4. Remove the 6 hooks (B).
5. Open the keyboard from LCD side and then turn it
inside out on the top case.
Note:
It can remove with the keyboard hook plate.
DIMM Cover
Baattrey Pack
Hook (A)
Screw (A)
Screw (B)
Screw (B)
Screw (B)
Keyboard Hook Plate
Keyboard Hook Plate