Filter
Top Products
Table 6-1: Two-Module Communications Port Switch Settings.
CUBICLE #1 - SSC
CUBICLE #2 - UPS 1 CUBICLE #3 - UPS 2
GTCZ / RAUZ1 UPS 1 GTCZ / RAUZ1 COM 2 UPS 2 GTCZ / RAUZ1 COM 2
Dip Switch “O” OPEN Dip Switch “O” OPEN Dip Switch “O” OPEN
Dip Switch “P” OPEN Dip Switch “P” OPEN Dip Switch “P” OPEN
Dip Switch “N” OPEN Dip Switch “N” OPEN Dip Switch “N” CLOSED
Dip Switch “M” CLOSED Dip Switch “M” OPEN Dip Switch “M” OPEN
Dip Switch “K” CLOSED Dip Switch “K” OPEN Dip Switch “K” OPEN
Dip Switch “L” CLOSED Dip Switch “L” OPEN Dip Switch “L” OPEN
Dip Switch “J” CLOSED Dip Switch “J” OPEN Dip Switch “J” OPEN
6.4 Communications Port 2 Personalization
Each cubicle must be personalized for its own communication port address. Personalization of each cubicle is set
at the time of order. Changing of personalization requires qualified personnel. Contact MGE Customer Support
Services at 1-800-438-7373.
Data for each configuration:
Data Rate: 9600 Baud
Data Bits: 8 (always)
Parity: None
Stop Bits: 1
Slave Address: (Hexadecimal)
- For Single-Module see section 6.4.1
- For Multi-Module see sections 6.4.2 and 6.4.3.
Interface: RS485
GCC Troubleshooting
Graphical Command Center
page 6 —4