Filter
Top Products
3-4
2. Placing Originals
Making Copies Chapter 3
(“Book” refers to an open bound original.)
Place the open book so that its top edge is at
the rear of the copier and the center of the
book is aligned with the Book Marker
indicated on the Original Length Scale.
Gently lower the Duplexing Document
Feeder or Original Cover.
NOTES
• If the book is thick, make a copy with the
Duplexing Document Feeder or Original Cover
raised.
• Do not look directly at the Original Glass
surface as a strong beam of light is emitted.
• Not positioning the open book properly will
result in copies with pages in incorrect order.
• Start copying with the higher-numbered pair.
Make sure of the correct placement of the original
in any of the following cases if the copier is
equipped with a Duplexing Document Feeder.
• Making copies in the Photo mode
•Making 12”×18” copies from an 11”×17”
original
Place the original, by aligning the rear edge
with the Length Scale and the left edge with
the (Photo) mark.
Gently lower the Duplexing Document
Feeder or the Original Cover.
Make settings in the Photo Mode.
☞ p. 3-33
• Be sure to raise the Duplexing Document Feeder
15° or more before placing the original. If the
Duplexing Document Feeder is raised to an
angle less than 15°, the copier may fail to select
the correct copy paper size or zoom ratio.
• Do not place an original weighing more than
4-1/2 lbs. on the Glass.
• When placing an open book, do not press the
book hard on the Glass, as the Glass could crack.
Making Copies from A Book Using
Book Copy Mode
1
1155O027AA
1154O003AA
Original Length Scale
Book Marker
2
When Copier is Equipped with a
Duplexing Document Feeder
Instructions for Original Placement
1
1144Y002AA
PHOTO Mark
2
3
1144O010AA
15°