Filter
Top Products
68
80
80
50QMA
50QMA
N/B Maintenance
N/B Maintenance
Reassembly
1. Replace the cable to the LCD panel.
2. Attach the LCD panel’s brackets back to LCD panel and secure with four screws.
3. Replace the LCD panel into LCD housing and secure with ten screws.
4. Reconnect one cable to inverter board.
5. Fit the LCD cover and secure with two screws and rubber pads.
6. Replace the LCD assembly, modem card, DDR, CD/DVD-ROM drive, hard disk drive, CPU, keyboard and
battery pack. (Refer to previous section reassembly)
Figure 2-23 Free the LCD panel
5. Remove the four screws that secure the LCD brackets. (Figure 2-22)
6. Disconnect the cable to free the LCD panel. (Figure 2-23)
Figure 2-22 Remove the four screws
MiTac Secret
Confidential Document