Filter
Top Products
133
CHAPTER 7 COMMUNICATION OF THE ETHERNET ADAPTER MODULE
7
7.4 MELSOFT Connection
7.4.1 Connection through a hub
1. Set "Ethernet Board" for PC side I/F.
In the "PC side I/F Ethernet Board Setting", configure the settings as shown below.
The IP address of the connected Ethernet adapter module is 192.168.3.30.
2. Set "Ethernet Module" for PLC side I/F.
In the "PLC side I/F Ethernet Module Setting", configure the settings as shown below.
3. Specify the other station
Set the destination CPU
For the setting method, refer to the following.
GX Works2 Version1 Operating Manual (Common)
• Network No. : The third octet value of the Ethernet adapter module's IP address
• Station No. : Any value of 1 to 64
• Protocol : TCP
• Model name : QJ71E71
• Station No. : Any value of 1 to 64 that does not overlap the Station No. set in the "PC side I/F
Ethernet Board Setting"
• IP address : Ethernet adapter module's IP address
Ex.
Set 3 for the network number.
192. 168. 3. 30