Filter
Top Products
222
Appendix 6 Resetting Parameters to Factory Default
Values
This section explains how to reset the parameters of the Ethernet adapter module to factory default values.
Perform the following when an IP address set in the configuration tool is unknown.
Parameters other than IP addresses will be also reset to factory default values.
1. Power on the module.
2. Move the switch on the Ethernet adapter module
from STOP RESET/TEST STOP in less than 1
second, and repeat this cycle ten times. (Then the
MODE and ERR. LEDs start flashing.)
When canceling the reset operation, shift the switch to
RUN.
3. Move the switch to RESET/TEST and hold it for 1
second.
Switch
Repeat at intervals of less than 1s.
: Flashing
Switch
1s or longer