Filter
Top Products
189
CHAPTER 10 CONFIGURATION TOOL
10
10.3 Parameters
10.3.3 Ethernet setting
10.3.3 Ethernet setting
Configure the settings for connecting the Ethernet Adapter Module to the Ethernet.
Setting item tree NZ2GF-ETB [Parameter] "Ethernet"
The following table lists the setting items on the dialog box.
*1 Restrictions apply to IP addresses that can be set to perform the communications described on the next page. Build the
system so that the IP address within each setting range described on the next page can be set.
Item Description Setting range
IP Address
Input Format Select an input format for the IP address and subnet mask pattern.
DEC/HEX
(Default: DEC)
IP Address
Set the IP address of the Ethernet Adapter Module.
If the IP address was changed, configure the network settings again.
(
Page 175, Section 10.1.1 (3))
• Decimal input
0.0.0.1 to 223.255.255.254
*1
(Default: 192.168.3.30)
• Hexadecimal input
0.0.0.1 to DF.FF.FF.FE
*1
(Default: C0.A8.03.1E)
Subnet Mask
Pattern
Set the subnet mask of the Ethernet Adapter Module.
If the subnet mask was changed, configure the network settings again.
(
Page 175, Section 10.1.1 (3))
• Decimal input
192.0.0.0 to 255.255.255.252
(Default: 255.255.255.0)
• Hexadecimal input
C0.0.0.0 to FF.FF.FF.FC
(Default: FF.FF.FF.00)
Communication Mode Set the communication mode.
Auto Negotiation
100Mbps/Half Duplex
100Mbps/Full Duplex
(Default: Auto Negotiation)
Connection Setting
Set connections. (
Page 191, Section 10.3.3 (1))
Disable direct MELSOFT connection. Specify whether to disable direct connections to MELSOFT.
Disable/not disable
(Default: Not disable)