Filter
Top Products
58
6. The unit test starts.
The MODE LED starts flashing, and the ×1 and ×10
LEDs repeat turning and off in the sequence of
12481... and so on.
7. When the unit test is completed, flashing of the
×1 and ×10 LEDs is stopped, and the D LINK
LED turns on.
• When completed
The D LINK LED turns on with the ERR. LED off.
• When failed
The following LEDs turn on.
• Either of the
×1 and ×10 LEDs
•ERR. LED
• D LINK LED
If the unit test fails, replace the Ethernet cable and
perform the test again. If it fails again, the Ethernet
adapter module may have hardware failure. Please
consult your local Mitsubishi representative, with a
detailed explanation of the problem.
: On
: Flashing
When completed
When failed
: On
: Flashing
: On
: Flashing