Filter
Top Products
EDS-508 Series User’s Manual Featured Functions
3-50
Mail Server IP/Name
Setting Description Factory Default
IP address The IP Address of your email server. None
Account Name
Setting Description Factory Default
Max. 45 Charters Your email account. None
Password Setting
Setting Description Factory Default
Disable/Enable to
change Password
To reset the Password from the Web
Browser interface, check-mark the Change
password check-box, type the Old
Password, type the New Password, retype
the New password, and then click on
Activate.
Disable
Old Password Type current password when enabled to
change password; Max. 45 Characters.
None
New Password Type new password when enabled to
change password.
None
Retype Password If you type a new password in the
Password field, you will be required to
retype the password in the Retype new
password field before updating the new
password.
None
Email Address
Setting Description Factory Default
Max. 30
Characters
You can set up to 4 email addresses to
receive alarm emails from EDS.
None
Send Test Email
After finishing with the email settings, you should first press the “Activate” button to activate
those settings, then press the “Send Test Email” button to verify that the settings are correct.
NOTE
Auto warning e-mail messages will be sent through an authentication protected SMTP server
that supports the CRAM-MD5, LOGIN, and PAIN methods of SASL (Simple Authentication
and Security Layer) authentication mechanism.
We strongly recommend not entering your Account Name and Account Password if auto
warning e-mail messages can be delivered without authentication mechanism.
Configuring Relay Warning
The Auto Relay Warning function uses relay output to alert the user when certain user-configured
events take place. There are three basic steps required to set up the Relay Warning function:
1. Configuring Relay Event Types
Select the desired Event types from the Console or Web Browser Event type page. (A
description of each event type is given later in the Relay Alarm Events setting subsection.)