Filter
Top Products
35
Chapter 3 - Software Loading and Configuration
Deploy the VOIP Network
Deploying the VOIP network involves the VOIP Administrator developing the VOIP Dialing Directory
and deploying the preconfigured client MultiVOIPs to their remote sites. The remote site
administrators need only connect power to the preconfigured MultiVOIP, connect it to their Ethernet
LAN and predefined telephone equipment, and then wait for the phone directory database to be
downloaded.
The client units can be another MVP 800 or MVP 400 unit or a MultiVOIP 200-series. Therefore, the
deployment procedure for the remote site administrator may be more general, so you may need to
refer to the Cable Connection Figure in the Quick Start Guide. Perform the following procedure to
deploy your VOIP Network.
VOIP Administrator
1. Establish your VOIP Dialing Directory based on your Phone Directory Database for the numbers
to connect the MultiVOIPs to your VOIP network and the telephone extension number you need
to connect the Voice/Fax channels. A sample VOIP Dialing Directory is provided below for your
consideration and use.
To call from
Call Process
Dialing
Sequence
VOIP Dialing Directory
2. Send the client MultiVOIPs to their remote sites.
Remote Site Administrator
3. Unpack your MultiVOIP.
4. Connect one end of the power supply to a live AC outlet and connect the other end to the Power
connection on your MultiVOIP.
FXSE&M
FXO
PSTN
Ethernet Connection
Power Connection
10BASET
ETHERNET
POWER
Voice/Fax Channel
Connections
E&M
FXO
FXS
Figure 2-4. Remote Site Cable Connection
5. Connect a network cable to the ETHERNET 10BASE-T connector on the back of your MultiVOIP.
6. If you are connecting a station device such as an analog telephone, a fax machine, or a Key
Telephone System (KTS) to your MultiVOIP, connect one end of an RJ11 phone cord to the
Voice/Fax Channel 1 FSX connector on the back of the MultiVOIP and the other end to the
station device.