Filter
Top Products
57
Chapter 5 - Remote Configuration and Management
Verify that the Communication Type is set for COM Port and the Select Port box is set for
the COM port of your local PC.
In the Dial String box, enter the AT command for dialing (ATDT) plus the phone number of
the remote MultiVOIP.
If your Modem Initialization String, Initialization Response, or Connect Response values are
different than the defaults in the dialog box, refer to your modem user documentation and
change the default values to match your modem.
Click OK when you are satisfied with your selections.
6. Run the MultiVOIP Configuration program. Click Start | Programs | MultiVOIP | MultiVOIP
Configuration, or double click on the MultiVOIP Configuration icon in the MultiVOIP
program group.
7. The Dialing dialog box displays while software is dialing the remote MultiVOIP.
8. The Reading Setup dialog box displays.
9. The MultiVOIP Setup menu displays. This is the dialog box of the remote MultiVOIP.
10. After you have changed the configuration of the remote MultiVOIP, click Download Setup to
update the configuration. The remote MultiVOIP will be brought down, the new configuration
written to the unit, and the unit will reboot.
11. Click Exit when the downloading is complete.
12. The Hangup connection? dialog box displays
Click Yes to disconnect the phone connection to the remote site.
13. If the same telephone number is not going to be used again in the immediate future, you may
want to remove it from the Port Setup dialog box.