Net Optics Director Switch User Manual


 
Director
12
Plan the Installation
Before you begin the installation of your Director device, determine the following:
IP address of the Director device, or a range of IP addresses if you are deploying multiple Director devices
Net Mask for Director
IP address of the remote management console, if deployed over a WAN; this address is used for SNMP traps
Gateway to the remote management console, if deployed over a WAN
Port assignments and lters for the Network and Monitor port connections
Make sure you have a suitable location to install the Director device. For power redundancy, use two independent
power sources.
Unpack and Inspect the Director device
Carefully unpack the Director device, power supplies, and all cables that are provided. Director is delivered with the
following:
(1) Director device
(2) Power cords
Director Quick Install Guide (one sheet)
(1) CD containing the Director User Guide (this document)
Network and monitor cables
RS-232 DB9 cable for use with the CLI
Extended Warranty if purchased
Check the packing slip against parts received. If any component is missing or damaged, contact Net Optics Customer
Service immediately at +1 (408) 737-7777. (Note: XFP modules are ordered and shipped separately.)