Net Optics Director Switch User Manual


 
Director
30
Monitor Port 1
Network Port 5
lter add in_ports=n1.5 ip_proto=6 action=redir redir_ports=m.1
lter add in_ports=n1.5 ip_proto=17 action=redir redir_ports=m.1
Protocol =
TCP
Protocol =
UDP
+
Logical OR lter connectionFigure 29:
View lters
To view a list of all pending lters, enter lterlist. To view the active lters, enter lterrunning.
Net Optics> lter list
Filter #1
src_mac=00:00:00:00:00:00 dst_mac=00:00:00:00:00:00
src_ip=0.0.0.0/255.255.255.255,dst_ip=0.0.0.0/255.255.255.255,ip_proto=0000
l4_src_port=0000,l4_dst_port=0000,vlan=0000,action=redir
in_ports=t1.01
redir_ports=t1.02
Filter #2
src_mac=00:00:00:00:00:00 dst_mac=00:00:00:00:00:00
src_ip=0.0.0.0/255.255.255.255,dst_ip=0.0.0.0/255.255.255.255,ip_proto=0000
l4_src_port=0000,l4_dst_port=0000,vlan=0000,action=redir
in_ports=t1.02
redir_ports=t1.01
Filter #3
src_mac=00:00:00:00:00:00 dst_mac=00:00:00:00:00:00
src_ip=0.0.0.0/255.255.255.255,dst_ip=0.0.0.0/255.255.255.255,ip_proto=0000
l4_src_port=0000,l4_dst_port=0000,vlan=0000,action=redir
in_ports=n1.01,n1.02,n1.03,n1.04
redir_ports=m.01,m.10
IPv4 lter resource utilization: 2%
Net Optics>
Filter list commandFigure 30:
Tip! ___________________________________________________________________________________________________
The ID number (Filter #) shown above each lter in the lterlist is the ID that applies for lterdelid=<id> and
lterinsid=<id> commands, because all three commands act on the pending lter list. Do not use the IDs in a
lterrunninglist as the reference for lterdel or lterins commands.
________________________________________________________________________________________________________