Filter
Top Products
Switching Commands
191
ProSafe M4100 and M7100 Managed Switches
show lldp med remote-device
This command displays summary information about remote devices that transmit current
LLDP MED data to the system. You can show information about LLDP remote data received
on all ports or on a specific port.
Format show lldp med remote-device {<slot/port> | all}
Mode
Example: The following shows example CLI display output for the command.
(Switch) #show lldp med remote-device all
LLDP MED Remote Device Summary
Local
Interface Remote ID Device Class
--------- --------- ------------
0/8 1 Class I
0/9 2 Not Defined
0/10 3 Class II
0/11 4 Class III
0/12 5 Network Con
show lldp med remote-device detail
Use this command to display detailed information about remote devices that transmit current
LLDP MED data to an interface on the system.
Format show lldp med remote-device detail <slot/port>
Mode
Privileged EXEC
Term Definition
Interface
The interface in a slot/port format.
Device Class
The Remote device’s MED Classification. There are four different kinds of devices, three
of them represent the actual end points (classified as Class I Generic [IP Communication
Controller etc.], Class II Media [Conference Bridge etc.], Class III Communication [IP
Telephone etc]). The fourth device is Network Connectivity Device, which is typically a
LAN Switch/Router, IEEE 802.1 Bridge, IEEE 802.11 Wireless Access Point etc.
Privileged EXEC
Term Definition
Supported
Capabilities
Shows the supported capabilities that were received in MED TLV on this port.
Enabled
capabilities
Shows the enabled capabilities that were enabled in MED TLV on this port.