Filter
Top Products
Management Commands
657
ProSafe M4100 and M7100 Managed Switches
no passwords strength maximum consecutive-characters
Use this command to reset the maximum number of consecutive characters to the default
value.
Format no passwords strength maximum consecutive-characters
Mode
passwords strength maximum repeated-characters
Use this command to enforce a maximum number of repeated characters that a password
should contain. An example of repeated characters is aaaa. The valid range is 0-16. If a
password has a repetition of characters more than the configured limit, it fails to configure.
The default is 0. A maximum of 0 means no restriction on that set of characters.
Format passwords strength maximum repeated-characters
Mode
Default
no passwords strength maximum repeated-characters
Use this command to reset the maximum number of repeated-characters to the default value.
Format no passwords strength maximum repeated-characters
Mode
passwords strength minimum character-classes
Use this command to enforce a minimum number of characters classes that a password
should contain. Character classes are uppercase letters, lowercase letters, numeric
characters, and special characters. The valid range is 0-4. The default is 4.
Format passwords strength minimum character-classes
Mode
Default
no passwords strength minimum character-classes
Use this command to reset the minimum number of character classes to the default value.
Format no passwords strength minimum character-classes
Mode
Global Config
Global Config
0
Global Config
Global Config
4
Global Config