NETGEAR M4100-D12G-POE+ Switch User Manual


 
Routing Commands
238
ProSafe M4100 and M7100 Managed Switches
Maximum Paths The maximum number of next hops in an OSPF route
Routing for
Networks
The address ranges configured with an OSPF network command
Distance The administrative distance (or route preference) for intra-area, inter-area, and external
routes
Default Route
Advertise
Whether OSPF is configured to originate a default route
Always Whether default advertisement depends on having a default route in the common routing
table
Metric The metric configured to be advertised with the default route
Metric Type The metric type for the default route
Redist Source A type of routes that OSPF is redistributing
Metric The metric to advertise for redistributed routes of this type
Metric Type The metric type to advertise for redistributed routes of this type
Subnets Whether OSPF redistributes subnets of classful addresses, or only classful prefixes
Dist List A distribute list used to filter routes of this type. Only routes that pass the distribute list are
redistributed
Number of Active
Areas
The number of OSPF areas with at least one interface running on this router. Also broken
down by area type
ABR Status Whether the router is an area border router. A router is an area border router if it has
interfaces that are up in more than one area
ASBR Status Whether the router is an autonomous system boundary router. The router is an ASBR if it is
redistributing any routes or originating a default route
RIP
Split Horizon Mode Whether RIP advertises routes on the interface where they were received
Default Metric The metric assigned to redistributed routes
Default Route
Advertise
Whether this router is originating a default route
Distance The administrative distance for RIP routes
Redistribution A table showing information for each source protocol (connected, static, bgp, and ospf). For
each of these sources the distribution list and metric are shown. Fields which are not
configured are left blank. For ospf, configured ospf match parameters are also shown
Interface The interfaces where RIP is enabled and the version sent and accepted on each interface
Parameter Description