Filter
Top Products
Switching Commands
22
ProSafe M4100 and M7100 Managed Switches
no auto-negotiate
This command disables automatic negotiation on a port.
Note: Automatic sensing is disabled when automatic negotiation is
disabled.
auto-negotiate all
This command enables automatic negotiation on all ports.
Default
Format auto-negotiate all
Mode
no auto-negotiate all
This command disables automatic negotiation on all ports.
Format no auto-negotiate all
Mode
description
Use this command to create an alpha-numeric description of the port.
Format description <description>
Mode
mtu
Use the mtu command to set the maximum transmission unit (MTU) size, in bytes, for frames
that ingress or egress the interface. You can use the mtu command to configure jumbo frame
support for physical and port-channel (LAG) interfaces. For the standard 7000 series
implementation, the MTU size is a valid integer between 1522–9216 for tagged packets and
a valid integer between 1518–9216 for untagged packets.
Note: To receive and process packets, the Ethernet MTU must include
any extra bytes that Layer-2 headers might require. To configure the
IP MTU size, which is the maximum size of the IP packet (IP Header
+ IP payload), see ip mtu on page 233.
enabled
Global Config
Global Config
Interface Config