NETGEAR M4100-D12G-POE+ Switch User Manual


 
Routing Commands
270
ProSafe M4100 and M7100 Managed Switches
composed of standard displayable, non-control keystrokes from a Standard 101/102-key
keyboard. The authentication key must be 8 bytes or less if the authentication type is simple.
If the type is encrypt, the key might be up to 16 bytes. Unauthenticated interfaces do not need
an authentication key. If the type is encrypt, a key id in the range of 0 and 255 must be
specified. The default value for authentication type is none. Neither the default password key
nor the default key id are configured.
Default
Format area <areaid> virtual-link <neighbor> authentication {none | {simple
<key>} | {encrypt <key> <keyid>}}
Mode
no area virtual-link authentication
This command configures the default authentication type for the OSPF virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the Router ID of
the neighbor
.
Format no area <areaid> virtual-link <neighbor> authentication
Mode
area virtual-link dead-interval (OSPF)
This command configures the dead interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the
Router ID of the neighbor. The range for seconds is 1–65,535.
Default
Format area <areaid> virtual-link <neighbor> dead-interval <seconds>
Mode
no area virtual-link dead-interval
This command configures the default dead interval for the OSPF virtual interface on the
virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is
the Router ID of the neighbor
.
Format no area <areaid> virtual-link <neighbor> dead-interval
Mode
none
Router OSPF Config
Router OSPF Config
40
Router OSPF Config
Router OSPF Config