Filter
Top Products
Quality of Service (QoS) Commands
473
ProSafe M4100 and M7100 Managed Switches
show service-policy
This command displays a summary of policy-oriented statistics information for all interfaces
in the specified direction.
Format show service-policy {in|out}
Mode
The following information is repeated for each interface and direction (only those interfaces
configured with an attached policy are shown):
Interface
Operational
Status
Policy Name
MAC Access Control List (ACL) Commands
This section describes the commands you use to configure MAC ACL settings. MAC ACLs
ensure that only authorized users have access to specific resources and block any
unwarranted attempts to reach network resources.
The following rules apply to MAC ACLs:
• The maximum number of ACLs you can create is hardware-dependent. The limit applies
to all ACLs, regardless of type.
• The system supports only Ethernet II frame types.
• The maximum number of rules per MAC
ACL is hardware-dependent.
mac access-list extended
This command creates a MAC access control list (ACL) identified by <name>, consisting of
classification fields defined for the Layer 2 header of an Ethernet frame. The <name>
parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely
identifying the MAC access list.
If a MAC ACL by this name exists, this command enters Mac-Access-List config mode to
allow updating the existing MAC
ACL.
Note: The CLI mode changes to Mac-Access-List Config mode when you
successfully execute this command.
Privileged EXEC
Term Definition
Valid slot and port number separated by forward slashes.
The current operational status of this DiffServ service interface.
The name of the policy attached to the interface.