Filter
Top Products
Utility Commands
559
ProSafe M4100 and M7100 Managed Switches
sntp server
This command configures an SNTP server (a maximum of three). The optional priority can be
a value of 1-3, the version a value of 1-4, and the port id a value of 1-65535.
Format sntp server <ipaddress|ipv6address| hostname> [<priority> [<version>
[<portid>]]]
Mode
no sntp server
This command deletes an server from the configured SNTP servers.
Format no sntp server remove <ipaddress|ipv6address| hostname>
Mode
clock timezone
When using SNTP/NTP time servers to update the switch’s clock, the time data received
from the server is based on Coordinated Universal Time (UTC) which is the same as
Greenwich Mean Time (GMT). This might not be the time zone in which the switch is located.
Use the clock timezone command to configure a time zone specifying the number of hours
and optionally the number of minutes difference from UTC. To set the switch clock to UTC,
use the no form of the command.
Format clock timezone zone-name +/-hours-offset [+/-minutes-offset]
Mode
Default no clock timezone
zone-name
hours-offset
minutes-offset
no clock timezone
This command sets the switch to UTC time.
Format no clock timezone
Mode
Global Config
Global Config
Global Config
Term Definition
A name to associate with the time zone
Number of hours difference with UTC
Number of minutes difference with UTC
Global Config