Filter
Top Products
119
Troubleshooting
Appendices
Troubleshooting
Problem Solution Page
“POWER” LED does not
light.
• Turn the UT-1 on.
• Confirm that the battery is
inserted and fully charged.
35, 43, 64
10, 92
Wireless transmitter
option not available.
Confirm that the UT-1 is
connected and on.
33, 42, 62
The Device info, and
Device settings menus
cannot be selected.
Confirm that the UT-1 is
connected and on.
33, 42, 62
Excessive radio
interference.
Adjust the position of the wireless
access point or host computer.
—
All LEDs flash at once.
UT-1 hardware or battery
malfunction. Contact a Nikon-
authorized service representative.
—
Camera displays TCP/IP or
FTP error.
• Check settings for host and/or
wireless LAN adapter and adjust
camera settings appropriately.
• Check firewall settings.
28, 56, 73
7
Camera displays wireless
error.
• Confirm that host and wireless
LAN adapter are on.
• Ensure that there are no
obstacles between UT-1 and
wireless LAN adapter.
• Check settings for host and/or
wireless LAN adapter and adjust
camera settings appropriately.
—
—
28, 56, 73
Camera displays “Ethernet
cable is not connected”.
Connect Ethernet cable or
change interface setting to
Wireless & Ethernet.
25, 53, 118
Memory card error
displayed.
Confirm that memory card is
properly inserted.
—