Filter
Top Products
45
PC Mode / Controlling the Camera
Using the UT-1 with a Computer
Controlling the Camera
1 Complete the steps in “Connecting to the Computer” (042).
2 Start Camera Control Pro 2 on the host
computer and confirm that “PC” is
displayed in the camera control panel.
3 Control the camera as described in the Camera Control Pro 2
manual or online help.
4 When transfer is complete, press the
power switch for about a second to turn
the UT-1 off and then disconnect the
USB cable.
D Wireless Networks
More time may be required to complete operations on wireless networks.
D Ethernet Networks: Do Not Disconnect the Ethernet Cable
Do not disconnect the Ethernet cable while the camera is on.
A Wireless Networks: Loss of Signal During Transfer
A loss of signal may interrupt the connection while pictures are being
transferred to Camera Control Pro 2. If the ERROR LED on the UT-1 is
flashing (02), turn the UT-1 off and then on again. Transfer will resume
when the connection is re-established. Do not turn the camera off.
Transfer can not be resumed once the camera has been turned off.
Power switch