Filter
Top Products
October 2006 Preparing for installation
1002rp Server Hardware Installation 35
6 For a DC-powered server, set up the DC power source (see
page 50).
❒
7 Place the 1002rp server in the chosen location (see page 60). ❒
8 Replace the front bezel (see page 44). ❒
9 Set the DIP switches on the modem (see page 61). ❒
10 Connect the 1002rp server and devices as follows:
Connect the monitor, keyboard, and mouse (see page 65). ❒
Connect the modem (see page 61). ❒
Connect the 1002rp server to the ELAN hub (Meridian 1 or
Succession 1000 only) (see page 68).
ATTENTION
To comply with EMC radiation requirements, a Class A hub
must be located 10 m (33 ft.) away from the 1002rp server.
Shielded Ethernet cables must be used.
❒
Note: If you are connecting the optional CLAN, do not power
up unless your antivirus programs and Nortel security updates
are installed first.
Connect the 1002rp server to the CLAN hub (optional) (see
page 71).
ATTENTION
To comply with EMC radiation requirements, a Class A hub
must be located 10 m (33 ft.) away from the 1002rp server.
Shielded Ethernet cables must be used.
❒
Install the software feature dongle (see page 73). ❒
Connect the power cords for all devices, and then power
them up.
❒
11 Start the 1002rp server (see page 75). ❒
Step Description Check