Filter
Top Products
October 2006 Power supply installation
1002rp Server Hardware Installation 49
To install the power supply module
The server is shipped with one power supply module installed in the bottom
power supply bay. You must install the second power supply module, as
described here:
1 Align the power supply module with the top power supply bay.
2 Slide the power supply module into the bay until the module is secured
by its connector.
Use some force, if necessary.
3 Secure the power supply module to the chassis with two thumbscrews at
the corners of the power supply faceplate.
What’s next?
Do one of the following:
.
DANGER
Risk of electric shock
High current inside the chassis can cause severe injury.
IF THEN
this is an AC-powered server continue with Chapter 5, “Installing
the server,” on page 60.
this is a DC-powered server continue with “DC wire gauge
tables,” on page 50.