Filter
Top Products
October 2006 Preparing for installation
1002rp Server Hardware Installation 41
To remove the server cover
1 Remove the front bezel (see page 40).
2 Loosen the three thumbscrews at the rear of the top cover.
3 Remove the server cover by pulling the cover toward the rear of the
chassis, and then lifting it up and off.
4 Clip the lead from your ESD wrist strap to an unpainted metal section of
the chassis.
What’s next?
Continue with “Inspecting the server interior” on page 42.
.
DANGER
Risk of electric shock
High current inside the chassis can cause severe injury.
.
CAUTION
Risk of equipment damage
Take precautions to protect internal components. Electrostatic
discharge (ESD) can render boards damaged or unusable. Wear
an ESD wrist strap.