Filter
Top Products
October 2006 Installing the server and connecting the peripheral devices
1002rp Server Hardware Installation 77
To connect the 1002rp AC server to power
1 Plug the server AC power cord into the server rear panel.
2 Plug the other end into a wall receptacle or power bar.
To connect the 1002rp DC server to power
1 Connect the DC power cable to the server.
.
WARNING
Risk of personal injury, risk of hardware failure
The power outlets used by the CallPilot server and its
peripheral devices must be connected to the same single-point
ground reference as the one used by the switch with MGate
cards (NTRB18CA) connected to the CallPilot server. If this
requirement is not met, power transients can cause personal
injury, or hardware failure, or both. Refer to the Installation
and Configuration Task List (555-7101-210) for more
information on single-point grounding requirements.
.
DANGER
Risk of electrical shock
Only qualified personnel can alter electrical connections.
Ensure the power distribution unit (PDU) is turned off
until you are instructed to turn it on.