Filter
Top Products
Chapter 1 Cables and power 25
Nortel VPN Router Installation — VPN Router 1750
3 Press and release the power switch on the rear of the VPN Router 1750, and
wait for the gateway to start.
Verifying a successful installation
After you connect the gateway to the power source and turn it on, you can verify a
successful installation by checking the light emitting diodes (LED) on the front
panel. For more information, see “Front panel LEDs” on page 26.
The following sequence of LEDs occurs:
1 The power LED (the Nortel logo) lights blue.
2 The Alert LED lights red and the Boot/Ready LED lights green.
3 When the gateway begins the boot sequence, the Boot/Ready LED lights
yellow and the Alert LED turns off.
4 After the boot process is complete, the Boot/Ready LED lights green, which
indicates that the gateway is operational.
5 The Alert LED lights yellow because the gateway is not configured.
For a newly installed VPN Router 1750, a yellow Alert LED does not indicate
an alarm condition. After you configure the gateway, the Alert LED turns off.
For more information, see Chapter 4, “Management IP interface
configuration,” on page 61.
If the LEDs on the front panel light in the preceding sequence, the installation is
successful. If the LEDs do not light in the preceding sequence, check that you
correctly installed the bezel on the gateway and that you properly attached the
power cord to the power supply. For more information, see “Connecting the power
cord” on page 24.
If the VPN Router 1750 still does not start, contact your local Nortel Technical
Solutions Center. For more information, see “How to get help” on page 15.