Filter
Top Products
50 Chapter 3 Option card and DIMM installation
NN46110-316 03.01
The first several times that you remove the front bezel, the bezel can stick
because the ball studs and socket clips are new.
To remove the top cover, perform the following steps:
1 Remove the router from the rack if it is mounted in an equipment rack.
2 At the front of the chassis, remove the two panhead screws that secure the
bottom of the chassis to the equipment rack.
3 Remove the VPN Router 1750 from the rack-mount shelf, and then set the
router on a sturdy surface.
4 Use a Phillips screwdriver to remove the four screws that secure the cover to
the chassis as shown in the following figure.
5 Slide the top cover forward approximately 1/4 inch.
CS260006A
Remove these 4 screws
Slide cover forward and lift up
Boot/Ready
Alert
Alert
Boot/Ready