Filter
Top Products
48 Chapter 3 Option card and DIMM installation
NN46110-316 03.01
Shutting down the system to add or replace hardware
To install or replace an option card or a DIMM, you must first shut down the VPN
Router 1750 and unplug it.
To shut down the VPN Router 1750, perform the following steps:
1 Use the Web graphical user interface (GUI) or the command line interface
(CLI) to shut down the gateway.
• Web GUI: Choose Admin, Shutdown. Select the option to turn off the
gateway after shutdown.
OR
• CLI: Use the
reload command to shut down the system. For example,
enter
reload power-off disable-logins “Upgrade hardware”
For more information about the reload command, see Nortel VPN
Router Using the Command Line Interface (NN46110-507).
2 Wait for the system to shut down.
3 Disconnect the power cord from the power outlet, and then disconnect the
power cord from the VPN Router 1750.
The power receptacle is on the rear of the VPN Router 1750 (see “Rear view
of the Nortel VPN Router 1750” on page 23).
Warning: Risk of electric shock
Before you attempt to add or replace an option card or DIMM, shut
down the VPN Router 1750 as described in this section.
Warning: Risk of electric shock
Make sure to turn off the VPN Router 1750 and unplug the power cord
before you attempt to remove or install an option card or DIMM.