Filter
Top Products
56 Chapter 3 Option card and DIMM installation
NN46110-316 03.01
2 Remove the filler panel screw, and pull out the filler panel (or the option card
to replace) from the slot as shown in the following figure.
3 Lower the new option card into the slot, and then gently press the connector
into the slot.
Seat the card in the slot. If you do not properly seat the card, it does not work.
4 Replace the screw that secures the card to the slot.
5 Replace the top cover on the chassis.
6 Hold the cover at an angle, and then slide it onto the chassis.
7 Use a screwdriver to insert and tighten the four screws that secure the cover to
the chassis.
Motherboard
Option card
Filler panel screw
Rear of unit
Option card slots
CS2600017A