Filter
Top Products
Chapter 3 Using the console interface 133
Using the BayStack 380 10/100/1000 Switch
LnkTrap Allows you to control whether link up/link down traps are sent to the configured trap
sink from the switch.
Default Value On
Range On, Off
Autonegotiation
When enabled, sets the corresponding port speed to match the best service provided
by the connected station, up to 1000 Mb/s in full-duplex mode. This field is disabled
for all fiber optic ports.
Default Value Enabled
Range Enabled, Disabled
Speed/Duplex
1
Allows you to manually configure any port to support an Ethernet speed of 10 Mb/s
100 Mb/s, in half- or full-duplex mode, or 1000 Mb/s in full-duplex mode. This field is
set (by default) to 1000 Mb/s, full-duplex for Gigabit ports only.
Default Value 1000Mbs/Full (when Autonegotiation is Disabled)
Range 10Mbs/Half, 10Mbs/Full, 100Mbs/Half, 100Mbs/Full, and
1000 Mb/s in full-duplex mode.
1 Fiber optic ports can only be set to 100 Mb/s/Half or 100 Mb/s Full.
Table 24 Port Configuration screen fields (continued)
Field Description