Filter
Top Products
OkiLAN 7120e Network User’s Guide
70
Check the network cable is correctly connected. The green LED near the
network interface should be lit. Otherwise, change the cable and try again.
If the standard configuration utility is used, check the NetWare network
number in the environment settings.
If the NetWare protocol is disabled, set it to
Enable.
Reset the network interface card to factory default settings.
The network interface card is identified by the setup utility but not
by the NetWare server.
Start up the NetWare server and check the NIC configuration.
Check the NSAP packet on the NetWare server is not set to
Disable.
Remote Server mode
Check the correct print server is operating on the file server.
Check the Print Server name operating on the File Server and the Print
Server name set in the NIC are the same.
Check the Printer name displayed in the Print Server monitor of the File
Server and the NetWare Port name set in the NIC are the same. If there
are multiple network interface cards, configure the NetWare Port names to
be different.
Print Server mode
Check the File Server name set in the NIC and on the File Server are the
same.
Check the Printer name set in the File Server and the NetWare Port name
set in the NIC are the same. If there are multiple NICs, configure the
NetWare Port names to be different.
Check the NetWare login password is correct.
Check the Machine name is the same as the Print Server name set in the
File Server.
Printer does not print.
Check the network cable is correctly connected.
Change the cable and try again.
Turn the printer off and on again.
Check the NIC is connected to the File Server.
Check the printer driver has been mapped to the correct netware queue.