Filter
Top Products
User’s Guide 13
English
SETTING
AUTO CONTINUE
WAIT TIME OUT
MANUAL TIME OUT
POWER SAVING
LOW TONER
CLEARABL WRNINGS
ERROR REPORT
SETTING
OFF*
ON
OFF*
5-90*-300 SECONDS
OFF
30 SEC
60 SEC*
0 SEC
8 MIN*
DISABLE
ON*
OFF
ON*
JOB
OFF*
ON
CATEGORY
AUTO OPERATION
POWER SAVING
LOW TONER
CLEARABL WRNINGS
EXPLANATION
The printer can recover from a memory overflow or print
overrun automatically after about 15 seconds if set to
ON, otherwise you will need to press the
Recover
key.
Most computer software will send a form feed character
at the end of the print job so that the last page is ejected.
If it does not, the printer can automatically eject the last
page after a period of inactivity.
This setting applies to PostScript operation only (when
installed). It determines how long the printer will wait for
a sheet to be inserted in the manual paper feeder.
When this function is active, power to the fuser is turned
off to conserve energy. A slightly longer delay will occur
before the next job prints, to allow the fuser to warm up
again.
This setting determines whether the printer will remain
on-line (ON) or go off-line (OFF) when one of the toner
cartridges has only enough toner left for about 100 pages.
Many messages which may appear from time to time
can be cleared by pressing the Recover key if this
function is ON. If it is set to JOB, the host computer may
be able to clear such warnings by downloaded
commands. This setting is not relevant when using
PostScript emulation.
In PostScript mode this setting determines whether an
error report will be printed when an error has occurred.