Filter
Top Products
38
OKIPAGE 8c Plus
Be careful not to touch any of the very hot surfaces
around the fuser unit. These are clearly indicated by
bright yellow warning labels.
1. Press the OPEN button and raise the top cover to its fully
upright position.
2. Push the small coloured locking lever (1) away from you
(towards the rear of the printer).
3. Lift the oil roller unit (2) by its right-hand end, pull it slightly
to the right to disengage the left-hand end from the fuser
unit, and lift the oil roller unit out of the printer.
4. Hold the new oil roller unit with the yellow warning label
on top and facing you.
Resetting Belt Count
After installing a new transfer belt the page counter for the belt
unit should be reset. This is performed using the User Menu.
1. Hold down the MENU 1 / Menu 2 key for about 2 seconds
until the menu item COLOR REG ADJUST appears in the
display.
2. Press and release the MENU 1 / Menu 2 key to cycle
through the available items. When the display shows
ENGINE CNT RESET, press ENTER.
3. Press and release the MENU 1 / Menu 2 key to cycle
through the available items. When the display shows BELT
COUNT press the ENTER key to reset the belt count.
4. Press the ON LINE key to exit from the User Menu and
return to the ON LINE (ready) condition.
Replacing Fuser Oil Roller
This unit should be replaced after approximately 10,000 pages.
Its purpose is to lubricate and clean the fuser roller, and if left
unchanged will result in poor print quality due to image offsetting
from the fuser.
1
2