Oki 8c Plus Printer User Manual


 
40
OKIPAGE 8c Plus
Replacing Fuser Unit
The fuser unit should be replaced after approximately 60,000
pages. When this unit needs replacing a message to that effect
will appear on the operator panel display.
Take care not to touch any of the very hot surfaces
around the fuser area. These are clearly indicated by
bright yellow warning labels.
1. Press the OPEN button and raise the top cover to its fully
upright position.
2. Push the two fuser latch levers (1) away from you (towards
the rear of the printer) to release the fuser unit.
3. Hold the fuser by its two handles (2) and lift the unit straight
up and out of the printer.
4. Fit a new fuser oil roller to the top of the new fuser,
following the instructions in the preceding section.
5. Hold the new fuser by its two handles, with the yellow
warning labels on top and facing you, and lower the unit
into the printer, pressing firmly down to fully locate the
unit.
6. Pull the two latching levers (1) towards you to ensure that
the fuser is locked into position. (It should not be possible
to lift the fuser when it is properly locked in position.)
7. Close the top cover and press down firmly at both sides to
ensure that it locks down.
1
2
1
2
1
1