Filter
Top Products
42
6. To listen to message 1 recorded previously, press the
key:
The display shows:
PLAYING
When it gets to the end of the message, the fax machine
automatically prepares to record a new OUTGOING
MESSAGE 1. In this case, if you like, you can change
or replace the message recorded previously by re-
peating the recording procedure.
7. To return the fax machine to the initial stand-by mode,
press the key:
8. If you want to move back one function, press the key:
TO RECORD OUTGOING MESSAGE 2
Record outgoing message 2 as you recorded OUTGOING
MESSAGE 1, modifying the step 4 as follows:
Press the
keys until the display shows:
TAD SET-UP
OGM 2
notE
Bear in mind however that you only have 10 seconds.
TO LISTEN TO OUTGOING MESSAGE 2
Play back outgoing message 2 as you played back OUTGO-
ING MESSAGE 1 modifying the step 4 as follows:
Press the
keys until the display shows:
TAD SET-UP
OGM 2
TO ERASE OUTGOING MESSAGE 2
This procedure can only be carried out from the fax
machine.
1. Press the key:
The display shows:
MENU
RECEPT. SET-UP
2. Press the keys
until the display shows:
MENU
TAD SET-UP
7. Press the key:
The display shows:
RECORD OGM #1
LIFT HANDSET
8. Lift the handset.
The display shows:
RECORD OGM #1
<|> TO RECORD
9. To start recording the message, press the key:
You have 20 seconds (counted on the display) to record
your message:
• if the message lasts less than 20 seconds, when you
reach the end of the message hang up or press the
key.
• the fax machine automatically plays back the message
you have recorded.
notE
If the volume of the message is too low or too high you can
regulate it, during playback, using the
key. The display
shows the volume level set on the bottom line.
TO LISTEN TO OUTGOING MESSAGE 1
1. Press the key:
The display shows:
MENU
RECEPT. SET-UP
2. Press the keys
until the display shows:
MENU
TAD SET-UP
3. Press the key:
The display shows:
TAD SET-UP
ICM ON SPEAKER
4. Press the keys
until the display shows:
TAD SET-UP
OGM 1
5. Press the key:
The display shows:
OGM 1
PLAY