Omron C200HW-CLK21 Network Card User Manual


 
24
Specifications and Configurations Section 1-2
Controller Link Support Software Menu Overview
Note 1. Refer to the Controller Link Support Software Operation Manual (W308)
for detailed operating procedures.
2. Use the CX-Net in CX-Programmer version 5.0 or higher to set data link
areas in which the number of send and receive words exceeds 12,000, or
to set data link tables that allocate the same area for Area 1 and Area 2.
Controller Link Support Software cannot be used for these settings.
3. For automatic data link creation with 1:N allocations or when changing
data link tables while the data link is active (CS1W-CLK21-V1 and CJ1W-
CLK21-V1), use the CX-Net in CX-Programmer version 3.2 or higher. Con-
troller LInk Support Software cannot be used to perform these functions.
CX-Programmer
The CX-Net operations within the CX-Programmer is required when using
user-set data links, or when setting or monitoring detailed settings of the Con-
troller Link Unit. This software can be used with a CS/CJ-series PLC and is
ideal for the following applications.
Setting the data link mode to “manual” (creating and storing data link
tables).
Starting/stopping data links.
Reading (monitoring) network status.
Reading error logs.
Setting routing tables.
Testing the Network.
Changing network parameters.
Menu items:
Edit table
Set Network parameters
Copy table
Routing tables
Initialize table
Echoback test
Check table
Broadcast test
Monitor Network
Display Error log
Display Node status
Display Board setup
Maintenance
Connection Info*
Edit PC ID
Unit backup
Board backup
Initialize network parameters
Save table
Retrieve table
Transfer table
Delete table
Print table
Start/Stop
Monitor status
Device info set
System setup
*Optical Rin
g
Link Systems only.
Data Link