Filter
Top Products
54
Component Names and Functions Section 3-1
Note Even when the local node does not participate in the data link, the
indicator will be lit if there are manually set data links active on the
network.
For details refer to
9-1 Troubleshooting Using Indicators.
Dimensions (Unit: mm)
3-1-6 Wire-to-Wire Repeater Unit
32
110
122.8
15.8
k
bit/s
O
N
1
2
O
N
1
2
DC24V
INPUT
SL1
SL2
T/R2
T/R1
PWR
CS1W-RPT01
BD L
SHLD
BD H
BD L
SHLD
BD H
TER SW
ON
ON
SW1
BAUD
RATE
1
2
TER SW
+
−
SL1 Terminal Block for Communications
Cable
Terminals to connect to the Controller
Link Network communications cable
(twisted-pair cable).
Baud rate switch
Power Terminal Block
Terminals to connect to the
power supply (24 V DC) that
drives the Repeater Unit.
Indicators
LED indicators that display the status of the
Unit and communications.
Terminating Resistance Switch for SL1
Turn ON this switch when the Repeater Unit is
connected to the SL1 communications cable
terminal block at either end of the Controller
Link Network.
Terminating Resistance Switch for SL2
Turn ON this switch when the Repeater Unit is
connected to the SL2 communications cable
terminal block at either end of the Controller
Link Network.
SL2 Terminal Block for Communications
Cable
Terminals to connect to the Controller
Link Network communications cable
(twisted-pair cable).