Filter
Top Products
18
Setting the RAID function (continued)
When RAID is re-set, the data on the HDD will be
deleted so take care before proceeding.
This is used when specifying either JBOD mode with
separate logical drive names for each HDD or RAID1
mode with mirrored HDDs.
This job is required when installing a new HDD.
A
B
(In the RAID1 mode)
D
C
E
(In the JBOD mode)
A
B
D
C
E
A
RAID1 button
This is used when writing the same data
simultaneously onto two HDDs.
B
JBOD button
Using each HDD as an individual device.
C
HDD-related information
The HDD manufacturer name, product number, and
disk size will be displayed on the right-hand side of
the button.
In JBOD mode, the HDD may be selected with the
button on the left.
D
NEXT button
This continues settings.
E
CLOSE button
Return to the main screen.
Setting up RAID drives (Create RAID)
Viewing basic RAID information
(Basic Information)
The statuses concerning the HDDs used and RAID are
displayed.
A
B
C
A
Physical Drive
The following information about the HDD installed is
displayed.
● Drive Model
Display the HDD product numbers.
●
Port
Display the numbers of the ports where the RAID
boards are connected
● Temperature
Display the temperatures of the HDDs
● Capacity
Display the memory sizes of the HDDs
● Status
Display the statuses of the individual HDDs
B
Logical Drive
● Assigned Name
Display the setting names
● Raid Level
Display either JBOD or RAID1
● Capacity
Display the memory size of the HDDs
● Status
Display the statuses
● UNMOUNT button (page 17)
Press this when logically isolating the HDD
before it is unmounted.
If the HDD is not installed, this button will not be
displayed.
C
CLOSE button
Return to the main screen.