Filter
Top Products
21
RAID Settings
The basic processing of the RAID1 function is set.
A
B
C
D
E
A
Rebuild Rate
Set the rebuilding rate.
While the rebuilding process is underway, both
playback and access from an external source via
the LAN can be performed at the same time.
When rebuilding and playback or rebuilding and
external access have been performed at the same
time, the rate of not only the rebuilding but the
playback or external access as well will be reduced.
For details on the rates provided by the LOW
button, MEDIUM button and HIGH button, refer to
the table below.
LOW
button
MEDIUM
button
HIGH
button
Rebuilding time
Slow Normal* Fast
Playback frame
skip amount
Low
number of
frames
Middling
number of
frames
High
number of
frames
* The rebuilding time is about 2 hours for 500 GB.
The rebuilding times given are estimates only
and will vary depending on the HDD used and
operating environment.
B
Automatic Rebuilding Status
● Enable button
Rebuild automatically.
● Disable button
Rebuild manually.
To initiate rebuilding, press the START button of
the Rebuild tab.
C
Buzzer Status
These control the ON/OFF statuses of the BUZZER
on the RAID board. This BUZZER sounds when
trouble has occurred on the RAID button.
● Enable button
Buzz when HDD is plugged.
● Disable button
Be quiet all the time.
D
APPLY button
Register currently set details.
E
CLOSE button
Return to the main screen.
Setting the RAID function (continued)