Filter
Top Products
Loading Labels for the Optional Peel Mode:
Peel mode is an option that must be purchased separately. In
peel mode, the printer separates the backing paper from the
label. The next label is not printed until the completed one is
removed from the printer. Make sure the printer is configured for
on-demand mode and the correct supply type.
The minimum feed length is 1.5 inches for peel mode. We
recommend using 0.5-inch gap supplies in peel mode when
backfeed is disabled. Hold the leading edge of peeled labels
when printing on stock longer than six inches. You must use
non-perforated supplies for peel mode. Follow the steps for
loading supplies from the previous section. Then, follow these
steps after you close the printhead.
1.
Remove the labels from the first 10 inches of the backing
paper.
2.
Press down on the exit cover tabs to open the exit cover on
the front of the printer.
Exit Cover
2-6
Loading Supplies