Filter
Top Products
757 Load supplies (supply length mismatch), because the
calibrated supply length differs by plus or minus .25
inches from the format. Press Feed/Cut.
758 Either the supply is not seen or the on-demand sensor
is broken. Check for a label jam, clear the supply path,
or reload supplies. This error may occur if you remove
a label too quickly in the on-demand mode.
763 Waiting to dispense label. Press Feed/Cut.
765 The printhead has less than 8 bad dots. The printer
can shift bar code fields to avoid bad dots. You may
need to press Escape/Clear to continue printing. Print
a test label to confirm the number of bad dots.
768 Printhead has more than 30 bad dots or is not
connected. Connect the printhead.
791 The printer has an error pending. Turn off the printer.
Wait 15 seconds (until the power light is completely
dim) and turn it back on. Resend the packets.
10-10
Using Diagnostics